Source: rigpix
Transceivers
Updated: 09/02/2026
Yaesu FTDX-101MP
Confidence score: 50%
Estimated value
2200€
Theoretical estimate
1900€
Minimum
2500€
Maximum
Specifications
GENERAL
- Type
- Amateur HF/VHF transceiver
- Frequency range
- TX: 10-160 m + WARC and 60 m / 6 m RX: 0.03-75 MHz (The European version also features 4 m/70 MHz)
- Tuning steps
- 1 / 5 / 10 Hz (SSB/CW) 10 / 100 Hz (AM/FM)
- Frequency stability
- ±0.1 ppm @ -10 to +60°C (14 to 140°F), after 1 minute warmup
- Mode
- AM / FM / SSB / CW / RTTY / PSK
- Channels / memory management
- 99 regular (Can be organized into 6 groups with 20 memories in each) 9 PMS pairs
- Repeater shift / offset
- ±0-1 MHz in 10 KHz steps (10 m) ±0-4 MHz in 10 KHz steps (6 m)
- Power supply
- Mains (FPS-101 external PSU with speaker, included as standard)
- Current drain / power consumption
- RX: 100 to 120 VA TX: Max 720 VA
- Antenna impedance / connector
- 50 ohm (ATU off)/ Three SO-239 HF: 16.7-150 ohm (ATU on) 6 m: 25-100 ohm (ATU on)
- Dimensions (W*H*D)
- 420*130*355 mm (16.6*5.1*12.7")
- Weight
- 13.5 Kg (29.8 lb)
- Other features
- CTCSS/PL. Voice memory. Dimmer. RTTY and PSK encode/decode. SD/SDHC card slot. Clock. 7-inch full color touch TFT. Twin RX. VC-tune units for both main and sub RX included from factory.
RECEIVER SECTION
- Receiver system
- Double conversion superheterodyne 1st IF: 9.005 MHz (Main) - 8.9 MHz (Sub) 2nd IF: 24 KHz (Main/Sub)
- Sensitivity
- AM (10 dB S+N//N. BW=6 KHz) 0.5-1.8 MHz: 6.3 uV 1.8-30 MHz: 2 uV (Amp2 on) 50-54 MHz: 1 uV (Amp2 on) 70-70.5 MHz: 2 uV (Amp2 on), Europe only FM (12 dB SINAD. BW=12 KHz. Amp2 on) 28-30 MHz: 0.25 uV 50-54 MHz: 0.2 uV 70-70.5 MHz: 0.25 uV, Europe only SSB/CW (10 dB S/N. BW=2.4 KHz. Amp2 on) 1.8-30 MHz: 0.16 uV) 50-54 MHz: 0.125 uV 70-70.5 MHz: 0.16 uV, Europe only
- Selectivity
- AM (BW=6 KHz. Width=Center) 6 KHz (-3 dB) 15 KHz (-60 dB) FM (BW=12 KHz. Width=Center) 12 KHz (-6 dB) 25 KHz (-60 dB) SSB (BW=2.4 KHz. Width=Center) 2.4 KHz (-3 dB) 3.6 KHz (-60 dB) CW (BW=500 Hz) 500 Hz (-3 dB) 750 Hz (-60 dB)
- Image rejection
- HF: 70 dB 6 m: 60 dB
- AF output power / speaker
- 2.5 W at 10% distortion / 4 ohm
- External speaker connector
- 3.5 mm, 4-16 ohm
TRANSMITTER SECTION
- Modulation system
- AM: Low-level, early stage FM: Variable reactance SSB: Balanced
- Max FM deviation (Factory set)
- FM: ±5 KHz NFM: ±2.5 KHz
- Spurious emissions
- HF: Better than -50 dB 6 m: Better than -66 dB
- Microphone impedance / connector
- 200 ohm to 10 Kohm (600 ohm nominal) / 8-pin (Metal locking ring connector)
- Microphone input level
- ? mV
User reviews
Write a review
Share your experience with the Yaesu FTDX-101MP